1.1 本规程涵盖了确定地下注射用水形成的沉积物成分的各种检查和分析结果的报告方式。 1.2 除非另有规定，否则所有分析均应按照ASTM的试验方法进行。 注1: 同时根据实践中的规定报告水形成沉积物中的无机成分 D933 对于某些行业来说已经足够了，本规程规定了有机和生物材料以及无机成分的报告。 注2: 与地下注水行业的实践一致，报告包括将无机成分指定为进行分析的物种的可能分子组合。 1.3 以国际单位制表示的数值应视为标准值。本标准不包括其他计量单位。 1. 4. 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。 ====意义和用途====== 5.1 本规程规定了报告从其他试验方法获得的数据的方式。这样做是为了使所使用的报告格式标准化。

1.1 This practice covers the manner in which the various results of examination and analysis to determine the composition of deposits formed from water for subsurface injection are to be reported. 1.2 All analyses shall be made in accordance with the test methods of ASTM, unless otherwise specified. Note 1: While reporting of inorganic constituents in water-formed deposits as specified in Practice D933 is sufficient for certain industries, this practice provides for the reporting of organic and biological materials as well as inorganic constituents. Note 2: Consistent with practices in industries where subsurface injection of water is practiced, reporting includes specifying of inorganic constituents as probable molecular combinations of the species for which analyses are performed. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 5.1 This practice sets down the manner in which data obtained from other test methods should be reported. This is done in an effort to standardize the report form used.