1.1 本规范涵盖了用于现场空调或制冷装置连接、维修或更换的无缝铜管的要求。 注1: 用于空调和制冷系统中焊接或钎焊连接的配件在ASME标准B16.22中进行了说明。 注2: 实践中描述了通过焊接组装铜管系统 B828 。 注3: 规范中描述了连接铜管系统的焊料 B32 规范中描述了这些系统可接受焊剂的要求 B813 。 1.2 管道应由以下铜制成，除非另有规定，否则制造商可选择供应其中任何一种: 铜 UNS编号。 以前使用过 任命 描述 C10200 的 无氧气 残留脱氧剂 2000年 DLP 磷脱氧， 低残留磷 C12200 DHP 磷脱氧， 高残留磷 1.3 以英寸-磅为单位的数值应视为标准。括号中给出的值是国际单位制的数学转换，仅供参考，不被视为标准。 1. 4. 以下危险说明仅适用于 18.2.4 本规范的: 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This specification covers the requirements for seamless copper tube intended for use in the connection, repairs, or alternations of air conditioning or refrigeration units in the field. Note 1: Fittings used for soldered or brazed connections in air conditioning and refrigeration systems are described in ASME Standard B16.22. Note 2: The assembly of copper tubular systems by soldering is described in Practice B828 . Note 3: Solders for joining copper tubular systems are described in Specification B32 . The requirements for acceptable fluxes for these systems are described in Specification B813 . 1.2 The tube shall be produced from the following coppers, and the manufacturer has the option to supply any one of them, unless otherwise specified: Copper UNS No. Previously Used Designation Description C10200 OF Oxygen free without residual deoxidants C12000 DLP Phosphorus deoxidized, low residual phosphorus C12200 DHP Phosphorus deoxidized, high residual phosphorus 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 The following hazard statement pertains only to the test method described in 18.2.4 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.