1.1 本安全规范旨在减少儿童因独立式衣物储存装置倾倒而造成的伤害和死亡，包括但不限于高度为27英寸（686 mm）或更高的柜子、抽屉柜、抽屉柜，衣柜、衣柜、衣柜柜、衣柜、门柜和梳妆台 磅（13.6 kg）或更大，且包含3.2 ft 3. （90.6分米 3. )或更大的封闭存储容量。 1.2 本安全规范不包括书架单元，如书柜或娱乐家具、办公家具、餐厅家具、珠宝柜、底层抽屉存储单元、非卧室使用的临时/重点家具、洗衣房存储/分类单元或内置- 用于永久固定在建筑物上的装置，也不包括《消费者安全规范》中定义的“衣物储藏柜” 1598年 . 1.3 本安全规范旨在涵盖72个月以下的儿童。看见 注1 . 注1: 大多数（约80 %) 5岁或以下儿童死亡。 1.4 以英寸-磅单位表示的值应视为标准值。括号中给出的值是对SI单位的数学转换，仅供参考，不被视为标准值。 1.5 以下安全隐患警告仅适用于测试程序部分，第节 9 ，本安全规范: 本标准并不旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前建立适当的安全、健康和环境实践，并确定监管限制的适用性。 1.6 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《国际标准、指南和建议制定原则决定》中确立的国际公认标准化原则制定的。

1.1 This safety specification is intended to reduce injuries and deaths of children from hazards associated with tipover of free-standing clothing storage units, including but not limited to chests, chests of drawers, drawer chests, armoires, chifferobes, bureaus, door chests, and dressers, which are 27 in. (686 mm) or greater in height, 30 lb (13.6 kg) or greater in mass, and contain 3.2 ft 3 (90.6 dm 3 ) or greater of enclosed storage volume. 1.2 This safety specification does not cover shelving units, such as bookcases or entertainment furniture, office furniture, dining room furniture, jewelry armoires, underbed drawer storage units, occasional/accent furniture not intended for bedroom use, laundry storage/sorting units, or built-in units intended to be permanently attached to the building, nor does it cover “Clothing Storage Chests” as defined in Consumer Safety Specification F2598 . 1.3 This safety specification is intended to cover children up to 72 months. See Note 1 . Note 1: The majority (approximately 80 %) of deaths relate to children 5 years or younger. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5 The following safety hazards caveat pertains only to the test procedure portion, Section 9 , of this safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.