1.1 本规范规定了屋面、覆层、泛水、排水沟、落水管和建筑施工用一般金属板工程的扁平长度或盎司厚度卷制铜板和铜带的要求。 1.1.1 根据本规范生产的产品不适用于电气应用。 1.2 单位- 以英寸-磅为单位的数值应视为标准值。括号中给出的值是到国际单位制的数学转换，仅供参考，不被视为标准值。 注1: 规格 B101型 是建筑施工用铅涂层铜板和铜带的相关规范。 1.3 以下危险警告与本规范第16节试验方法部分有关 1.3.1 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification establishes the requirements for rolled copper sheet and strip in flat lengths or coils in ounce-weight thicknesses for roofing, cladding, flashings, gutters, downspouts, and general sheet metal work for building construction. 1.1.1 Products produced to this specification are not intended for electrical applications. 1.2 Units— The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Note 1: Specification B101 is an associated specification for lead-coated copper sheets and strip for building construction. 1.3 The following hazard caveat pertains to the test methods portion, Section 16, of this specification 1.3.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.