本文件规定了根据EN 13941-1，工厂制造的热水网络用隔热粘结配件组件的要求和试验方法，包括钢制服务配件、硬质聚氨酯泡沫隔热材料和聚乙烯外壳。 配件组件还可以包括以下附加元件:测量线、垫片和扩散屏障。 本文件涵盖以下配件组件:弯头、三通、异径管、一次性补偿器和锚固件。 本文件适用于最小设计压力为1.6 MPa（超压）的配件组件。交叉引用:EN ISO 17638EN 12814-1EN ISO 5579EN 10253-2EN 14870-1EN ISO 5817EN ISO 15607EN ISO 3452-1EN ISO 9606-1EN ISO 14732EN ISO 9692-1:2013EN ISO 8501-1EN ISO 17637EN ISO 1166EN 253EN 17248EN 10217-2EN ISO 23278ISO 6761EN ISO 10675-1EN ISO 23277EN ISO 17640EN 10217- 5EN 13941-1EN 14419EN 10216-2EN ISO 17636-1EN ISO 17636-2EN 13018EN 13941-2EN 10204EN ISO 16810EN ISO 9934-1EN 489-1EN 15698-1ISO 2859-2EN ISO 9001EN ISO 2553EN 15698-2EN 488EN 15632（所有部分）购买本文件时提供的所有当前修订版均包含在购买本文件中。

This document specifies requirements and test methods for factory made thermally insulated bonded fitting assemblies for hot water networks in accordance with EN 13941-1, comprising a steel service fitting, rigid polyurethane foam thermal insulation and a casing of polyethylene. The fitting assembly could also include the following additional elements: measuring wires, spacers and diffusion barriers. This document covers the following fitting assemblies: bend, tee, reducer, single use compensator and anchor. This document applies to fitting assemblies with a minimum design pressure of 1,6 MPa (overpressure).Cross References:EN ISO 17638EN 12814-1EN ISO 5579EN 10253-2EN 14870-1EN ISO 5817EN ISO 15607EN ISO 3452-1EN ISO 9606-1EN ISO 14732EN ISO 9692-1:2013EN ISO 8501-1EN ISO 17637EN ISO 11666EN 253EN 17248EN 10217-2EN ISO 23278ISO 6761EN ISO 10675-1EN ISO 23277EN ISO 17640EN 10217-5EN 13941-1EN 14419EN 10216-2EN ISO 17636-1EN ISO 17636-2EN 13018EN 13941-2EN 10204EN ISO 16810EN ISO 9934-1EN 489-1EN 15698-1ISO 2859-2EN ISO 9001EN ISO 2553EN 15698-2EN 488EN 15632 (all parts)All current amendments available at time of purchase are included with the purchase of this document.