1.1 本指南涵盖了试验方法选择和相关试样设计，以产生用于典型螺栓连接分析的试验数据。这些测试方法仅限于使用由高模量纤维增强的多向聚合物基复合材料层压板。本标准旨在供要求进行此类试验的人员使用。 1.2 设计这些试样的测试请求者需要熟悉参考的测试方法和实践标准，CMH-17第3卷第11章，以及将使用最终设计数据的应力分析方法。 1.3 单位- 以国际单位制或英寸磅单位表示的数值应单独视为标准。每个系统中规定的值不一定是完全相等的；因此，为了确保符合标准，每个系统应独立使用，并且两个系统的值不得合并。 1.3.1 在文本中，英寸磅单位显示在括号中。 1.4 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This guide covers the test method selection and associated test specimen design to produce test data to be used for typical bolted joint analyses. These test methods are limited to use with multi-directional polymer matrix composite laminates reinforced by high-modulus fibers. This standard is intended to be used by persons requesting these test types. 1.2 Test requestors designing these specimens need to be familiar with the referenced Test Method and Practice standards, CMH-17 Volume 3 Chapter 11, and the stress analysis methods that will use the resulting design data. 1.3 Units— The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.3.1 Within the text the inch-pound units are shown in brackets. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.