这是一个可搜索的PDF。1.1范围1。1.1本标准适用于新生产的先导气体过滤器，以下简称过滤器（见第四部分，定义），完全由新的、未使用的零件和材料制成。过滤器符合本标准并不意味着过滤器可用于燃气器具，无需对特定器具设计中使用的过滤器进行补充试验。1.1.2本标准适用于最大工作气体压力额定值为1/2 psi的过滤器。1.1.3符合本标准规定的过滤器应被视为具有32°C的工作温度范围？F到125？F（0摄氏度至51.5摄氏度）。当制造商规定时，它们可以在较高温度、较低温度或两者下运行。1.1.4如果本标准中给出的测量值后跟其他单位的等效值，则第一个规定值应视为规范值。 1.1.5除非另有规定，否则本标准中提及的所有psi均应视为表压。1.1.6附件A包含加拿大独有的条款。1.1.7附件B包含本标准中特别引用的标准列表，以及可获得这些标准的来源。

This is a searchable PDF.1.1Scope1.1.1This standard applies to newly produced pilot gas filters, hereinafter referred to as filters (See Part IV, Definitions), constructed entirely of new, unused parts and materials.Compliance of a filter with this standard does not imply that the filter is acceptable for use on gas appliances without supplemental tests with the filter applied to the particular appliance design.1.1.2This standard applies to filters having maximum operating gas pressure ratings of 1/2 psi.1.1.3Filters complying with the provisions of this standard s hall be considered as having an operating temperature range of 32?F to 125?F (0?C to 51.5?C). They may be capable of operation at a higher temperature, lower temperature, or both, when so specifi ed by the manufacturer.1.1.4If a value for measurement as given in this standard is followed by an equivalent value in other units, the first stated value is to be regarded as the specification.1.1.5All references to psi throughout this standard are to be considered gage pressures unless otherwise specified.1.1.6Exhibit A contains provisions that are unique to Canada.1.1.7Exhibit B contains a list of standards specifically referenced in this standard, and sources from which they may be obtained.