1.1 本规程涵盖工厂制造的圆形波纹钢管配件的钢筋结构设计，符合规范要求 A760/A760M 或 A762/A762M ，用作雨水和卫生下水道以及其他埋地应用。本规程适用于安装在沟渠或路堤中并承受土荷载和活荷载的管道上的配件。必须认识到，埋地波纹管是由钢环和土包层组成的复合结构，这两个元件都起着至关重要的作用。主管和支管均应按照实践进行设计 A796/A796米 并按照惯例进行安装 A798/A798M . 1.2 本规程涵盖配件（如支管配件）的钢筋结构设计。请参阅第节 5. 设计限制。 1.3 以国际单位制或英寸磅单位表示的数值应单独视为标准。每个系统中规定的值不一定是完全相等的；因此，为了确保符合标准，每个系统应独立使用，并且不得将两个系统的值组合使用。 1.4 本标准并不旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This practice covers the structural design of reinforcement for fittings in factory-made, round corrugated steel pipe, conforming to Specifications A760/A760M or A762/A762M , for use as storm and sanitary sewers and other buried applications. This practice is for fittings on pipe installed in a trench or embankment and subjected to earth loads and live loads. It must be recognized that a buried corrugated pipe is a composite structure made up of the steel ring and the soil envelope, and both elements play a vital part. Both main and branch pipe shall be designed in accordance with Practice A796/A796M and installed in accordance with Practice A798/A798M . 1.2 This practice covers the structural design of reinforcement for fittings such as those for branch pipes. Refer to Section 5 for design limitations. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.