IEC 60317-15:2019+AMD1:2010+AMD2:2024 CSV规定了180级漆包圆铝绕组线的要求，该绕组线具有基于聚酯亚胺树脂的唯一涂层，如果保留了原始树脂的化学特性并满足所有规定的电线要求，则可以对其进行修改。180级是热等级，要求最低温度指数为180，热冲击温度至少为200°C。与温度指数对应的温度（摄氏度）不一定是建议操作电线的温度，这将取决于许多因素，包括所涉及的设备类型。本标准涵盖的标称导体直径范围如下:-1级: 0400毫米至1600毫米2级:0400 mm至5000 mm。标称导体直径在IEC 60317-0-3第4条中规定。与上一版相比，主要变化如下:-增加了外观的新要求，第3.2款；-弹性试验，第7条，被确定为不合适第10条中的贯通试验被确定为不合适高温失效试验，第22条，删除增加了新的销孔试验，第23条。

IEC 60317-15:2019+AMD1:2010+AMD2:2024 CSV specifies the requirements of enamelled round aluminium winding wire of class 180 with a sole coating based on polyesterimide resin, which may be modified providing it retains the chemical identity of the original resin and meets all specified wire requirements. Class 180 is a thermal class that requires a minimum temperature index of 180 and a heat shock temperature of at least 200 °C. The temperature in degrees Celsius corresponding to the temperature index is not necessarily that at which it is recommended that the wire be operated and this will depend on many factors, including the type of equipment involved. The range of nominal conductor diameters covered by this standard is as follows: - grade 1: 0,400 mm up to and including 1,600 mm; - grade 2: 0,400 mm up to and including 5,000 mm. The nominal conductor diameters are specified in Clause 4 of IEC 60317-0-3. The main changes with respect to the previous edition are listed below: - new requirements for appearance, Subclause 3.2, added; - springiness test, Clause 7, determined to be inappropriate; - cut-through test, Clause 10, determined to be inappropriate; - high temperature failure test, Clause 22, deleted; - new pin hole test, Clause 23, added.