1.1 本消费者安全规范规定了安全性能要求、测试方法和标签要求，以尽量减少哺乳枕头对婴儿的危害。 1.2 本消费者安全规范旨在最大限度地降低婴儿因正常使用和合理可预见的误用或滥用哺乳枕头而受伤和死亡的风险。 1.3 本消费者安全性能规范涵盖了任何填充、填充或模制的泡沫产品，这些产品旨在、销售或设计用于在哺乳或奶瓶喂养时将婴儿靠近护理人员的身体定位和支撑。一般来说，本产品将用于新生儿，直到婴儿停止哺乳或奶瓶喂养。这些产品可以放置、包裹或由护理人员以坐姿或斜躺姿势佩戴。 1.4 在本消费者安全规范批准日期后生产的任何护理枕头，除非符合本规范中的所有要求，否则不得通过标签或其他方式表明符合本规范。 1.5 以英寸-磅单位表示的值应被视为标准值。括号中给出的值是对国际单位制的数学转换，仅供参考，不被视为标准值 1.6 以下预防性警告仅适用于测试方法部分，第节 7. ，本规范。 本标准并不旨在解决与其使用相关的所有安全问题（如果有的话）。本标准的使用者有责任在使用前建立适当的安全、健康和环境实践，并确定监管限制的适用性。 1.7 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This consumer safety specification establishes safety performance requirements, test methods, and labeling requirements to minimize the hazards to infants presented by nursing pillows. 1.2 This consumer safety specification is intended to minimize the risk of injuries and deaths to infants resulting from normal use and reasonably foreseeable misuse or abuse of nursing pillows. 1.3 This consumer safety performance specification covers any stuffed, filled, or molded-foam product intended, marketed, or designed to position and support an infant close to a caregiver's body while nursing or bottle feeding. In general, this product will be used for infants from newborn until the infant ceases nursing or bottle feeding. These products rest upon, wrap around, or are worn by a caregiver in a seated or reclined position. 1.4 No nursing pillow produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard 1.6 The following precautionary caveat pertains only to the test methods portion, Section 7 , of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.