1.1本试验方法涵盖当安装在心轴上并在规定载荷下承受切削刃时，材料切削阻力的测量。 1.1.1本程序不适用于高孔隙率材料，该材料允许切割前切割边缘与安装表面接触，或厚度大于3 mm的材料。 1.2以国际单位制或其他单位表示的数值应单独视为标准值。每个系统中规定的值可能不是精确的等效值；因此，每个系统必须相互独立使用，不得以任何方式组合值。 1.3本标准无意解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全和健康实践，并确定监管限制的适用性。

1.1 This test method covers the measurement of the cut resistance of a material when mounted on a mandrel and subjected to a cutting edge under a specified load. 1.1.1 This procedure is not valid for high-porosity materials which allow cutting edge contact with the mounting surface prior to cutting, or for materials greater than 3 mm in thickness. 1.2 The values stated in SI units or in other units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.