IEC 60317-22:20 04+A1:2009规定了双涂层180级漆包圆铜绕组线的要求。底层涂层基于聚酯或聚酯酰亚胺树脂，只要其保留原始树脂的化学特性并满足所有规定的线材要求，就可以对其进行改性。叠加涂层基于聚酰胺树脂。180级是要求最低温度指数为180且热冲击温度至少为200℃的热等级。与温度指数相对应的以摄氏度为单位的温度不一定是推荐操作电线的温度，这将取决于许多因素，包括所涉及的设备类型。本标准涵盖的公称导体直径范围如下:-1级:0,050 mm至3,150 mm并包括3,150 mm； -2级:0,050 mm至5,000 mm并包括5,000 mm； -3级:0,250毫米至1,600毫米（含1,600毫米）。 IEC 60317-0-1第4条规定了标称导体直径。与上一版相比的主要变化如下: -增加了新的外观要求，第3.2款； -击穿电压值，前表3，替换为参考IEC 60317-0-1； -增加了新的针孔测试，第23条。 本合并版本由第三版（2004年）组成 及其修正案1（2009年）。因此，无须在 本出版物的补充。 本出版物应与IEC 60317-0-1:20 08一起阅读。

IEC 60317-22:2004+A1:2009 specifies the requirements of enamelled round copper winding wire of class 180 with a dual coating. The underlying coating is based on polyester or polyesterimide resin, which may be modified providing it retains the chemical identity of the original resin and meets all specified wire requirements. The superimposed coating is based on polyamide resin. Class 180 is a thermal class that requires a minimum temperature index of 180 and a heat shock temperature of at least 200 °C. The temperature in degrees Celsius corresponding to the temperature index is not necessarily that at which it is recommended that the wire be operated and this will depend on many factors, including the type of equipment involved. The range of nominal conductor diameters covered by this standard is as follows:
- grade 1: 0,050 mm up to and including 3,150 mm;
- grade 2: 0,050 mm up to and including 5,000 mm;
- grade 3: 0,250 mm up to and including 1,600 mm.
The nominal conductor diameters are specified in Clause 4 of IEC 60317-0-1. The main changes with respect to the previous edition are listed below:
- new requirements for appearance, Subclause 3.2, added;
- breakdown voltage values, former Table 3, replaced with a reference to IEC 60317-0-1;
- new pin hole test, Clause 23, added.
This consolidated version consists of the third edition (2004) and its amendment 1 (2009). Therefore, no need to order amendment in addition to this publication.

This publication is to be read in conjunction with IEC 60317-0-1:2008.