1.1本标准规定了第3条规定的工厂内平板玻璃的储存，处理和运输设备的设计和安装要求。适用于固定式，移动式和移动式存储设备（见3.2），机械和自动处理设备（见3.3）和运输设备（见3.4）（见附件A概述）。 1.2处理由工厂以外使用而产生的具体危害的附加要求，请参见prEN 13035-2。 1.3本标准仅涉及与玻璃直接接触的设备。拖拉机，起重机，起重机和叉车不在范围之内，也不在与玻璃接触的其他动力车辆的部件（见3.4.1）。本标准不适用于3.3.1中定义的手动搬运设备。 1.4本标准涉及与平板玻璃的储存，处理和运输有关的所有重大危险，危险情况和事件，如果按照预期使用并在制造商合理预见的误用条件下处理（见第4条）。本标准规定了消除或减少c中重大危害引起的风险的适当技术措施

1.1 This standard contains the requirements for safety for the design and installation of equipment intended for the storage, handling and transportation of flat glass inside the factory as described in Clause 3. It applies to stationary, movable and mobile storage equipment (see 3.2), mechanical and automatic handling equipment (see 3.3) and transportation equipment (see 3.4) (see overview in Annex A). 1.2 Additional requirements for dealing with specific hazards due to the use outside the factory are dealt with in prEN 13035-2. 1.3 This standard only deals with the devices which are directly in contact with the glass. Tractors, cranes, hoists and fork lifts are out of the scope as well as parts of other powered vehicles that are not in contact with the glass (see 3.4.1). This standard does not apply to manual handling equipment as defined in 3.3.1. 1.4 This standard deals with all significant hazards, hazardous situations and events relevant to equipment for the storage, handling and transportation of flat glass, when they are used as intended and under the conditions of misuse which are reasonably foreseeable by the manufacturer (see Clause 4). This standard specifies the appropriate technical measures to eliminate or reduce risks arising from the significant hazards during commissioning, the operation and maintenance. Noise has not been considered to be a significant hazard for any type of equipment in the scope of this standard. 1.5 This document is not applicable to storage, handling or transportation equipment for flat glass inside the factory, which is manufactured before the date of its publication as EN.